Basic Issue
- Check Fan and then Temperature sensor or thermostat and its resistor and diode connected with fan print. If every thing is ok then check the controller IC (28 pin)
Luminous Ecowatt+ 650
| Problem | continuous fan run on switch on + overload and Low battery issue |
| Fault | PCB Board fell down and thermostat pin shorted with the nearby print on the PCB. |
| Solution | First checked the mosfet, found OK. > Next traced the thermostat because the fan was running continuously, thermostat is ok. > Next checked the backside of the thermostat and found one pin of the thermostat pin shorted with the nearby print on the PCB. Removed the shorted pin and the inverter started successfully. Video. |
| Parts used | no parts used |
Related
Mains Voltage faults explained
Transformer Issue
Inverter repair tools
Charging section explanation
Display LED Problem
Low voltage output
Switch Problem
Reverse voltage output from AC input socket
Relay problem
Overload
Overheating
Overcharging
No charging
No voltage output from inverter back socket
Mosfet Blowing issue
Low battery Issue
Inverter going in mains mode when battery wires connected
Incorrect drive voltage in Mosfet
IC (28leg IC microcontroller) damaged or burnt
Humming sound
High Voltage output
Dead Inverter
Continuous Beep sound
Battery connectors shorting
Battery charging Full issue
Inverter Issues
Inverter Basics